Back to Basics SSP4 Specifikace stáhnout pdf (Strana 19)

Command

Return

STEMxy

none

Function:

This command sets the detector operating temperature in degrees celsius below 0.

Thus, a xy value of 05 will set the detector to -5 C.

Warning:

Only integer values from 00 to 40 are acceptable.

Table 4-5. Select Detector Temperature

Command

Return

SFTEMP

F=xy.z CR LF

Function:

This command gets the detector operating temperature in degrees centigrade below

0 and sends it on the serial interface. Resolution is approximately 0.2 C based on

the 8-bit A/D conversion algorithm. Thus, an output value of F=35.4 CR LF is an

operating detector temperature of -35.4 C.

Warning:

Only values from 00.0 to 44.9 are reported.

Table 4-6. Get Detector Temperature Command

Command

Return

SEXITn

“END” CR LF

Function:

This command exits the serial mode and returns control of the instrument to the 2-

button interface. The value of padding character n can be anything.

Table 4-7. Exit Serial Mode Command

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 34 35

Žádné komentáře

Back to Basics SSP4 Specifikace Strana 19